用“axially”造句大全，axially造句
Numerical calculation of average flow rate of the unsteady flow of a viscoelastic fluid in eccentric annulus with the inner cylinder reciprocating axially
Based on the limit equilibrium theory for axially symmetric condition, the active earth pressure of circular pit obtained with slip-line method was extended to non-uniform surcharge loading.
Abstract: In this paper, based on the creep analysis of axially compressed CFST( Concrete Filled Steel Tubular) short columnc, the effect of creep on confining stress was considered and an effective method to calculate confining stress in the procedure of creep was constructed.
For example, the diameter of a bar can be increased by heating and hammering axially.
Next we discuss the application of the RMF theory for the spherical and the axially symmetric deformed nuclei.
The front piece includes a foot portion defining an axially extending engagement surface for interference-fit engagement with the annular surface of the seal ring.
The pressure distribution along the curved wall of an axially symmetric inlet so obtained was calculated by the relaxation method, and that of another was measured from an air-flow model test.
Beginning from the influence of stiffness of axially mounted damper, a reasonable whole car dynamic model is established.
The temperature stress of I-profile short axially-restricted column is studied, a regression formula of temperature stress is proposed, and it agrees well with the experimental results.
axially strained two-mode fiber
The use of a snap ring inserted in the snap ring groove in the outer ring provides a particularly economic and axially space-saving arrangement (FIG 4).
Mechanical mandrel, axially actuated via machine pull rod.
New type of liquid crystals such as laterally fluorinated naphthalene indane, axially fluorinated cyclohexane and liquid crystal containing highly fluorinated substituent, which with high negative dielectric anisotropy low viscosity and high clearing point were emphasized.
They are axially guided by the axial sliding areas of the cage or by the lips of machined bearing rings.
Under such conditions the balls contact the inner and outer rings only at one point, as in an axially loaded single-row angular contact ball bearing.
