用“grinding process”造句大全，grinding process造句

MATLAB-based simulation method of surface's three-dimensional model in grinding process

The issues existed in rock wet grinding process matched with WPA plant and some improvement suggestions

D real scene of CAM shaft grinding process system is a basic function unit of the CAM shaft virtual reality grinding system in our research.

Experiments demonstrate that the grinding process has no special requirements for the type and hardness of the stone broach but the trimming process does.

This machine is suitable to grinding process for different sizes and thickness of the hemline, edges and corners of flat glass.

Real-time monitoring of grinding wheel motor current in the numerical control grinding processing

Three different test methods for grinding performance evaluation of grinding fluids were used to investigate the influence of three kind grinding fluids on grinding process.

The grinding process could be controlled either by grinding cycle parameters or by signals from gauge, which meets the grinding control requirements very well.

The grinding strengthen technology is a new process engineering of surface heat-treatment, which uses a mass of grind heat produced in grinding process to handle workpiece materials.

The more accurate grinding result can be obtained within shorter time, which can be seen especially in the grinding process of the thin thickness workpiece.

Block, backplane: high-quality oak molding by the mold pressing, grinding process by profiling, do the multi-layer paint finishes.

This article talks about the grinding process of the roll in several areas, according to the present production condition, the equipment capability and accuracy standards.

Adaptive control of grinding force in grinding process of planar cam

On line monitoring for grinding arc temperature is a necessary and important section to realize automation of grinding process.

There are many ways to arrange the grinding process for one roll.

The grind-hardening is the flourishing new technology recently, which martensitizes the metal material of workpiece surface and enhances its capability by heat generated during grinding process.

The investigation of surface quality and grinding forces of grinding processing of particle reinforced matrix aluminium composites

Pointing at problems produced in grinding process of bearing rings with double raceways, the dynamic control grinding process method is put forward.

The basic rules in grinding process has been derived, so as to carry out the proper adjustment and controlment for the circular grinding machine.

Belt grinding, called "universal grinding", a new grinding process, has been used for the heavy grind field with dry grinding, high speed, big cutting, and high-precision parts grinding.

The results indicate that increasing the vertical pressure or grinding speed is beneficial to the grinding process of ceramic corundum abrasive belt.

The difficulty in NC grinding is that the size of the work piece cannot be invariable because the grinding wheel will be abraded continuously in the grinding process.

The vibration magnitude of translational worktable is detected by eddy transducer, and hence the automatic regulation of the machine parameters is achieved,then a smooth grinding process is guaranteed.

Optimizing the closed-circuit grinding process to improve the water balance in WPA production

The change in particle size distribution of fly ash in grinding process and its influence on the activity of fly ash are presented in this paper.